Oracle 11g Step by Step Installation

If you are installing on Non-Network Computer than it is recommended to disable your wireless connectionInstall Loop back adapter using the following steps.

  • Initiate the run window by pressing the Windows + R button. The following screen will appear.

  • Type the following command on this window and press enter

  • The following window will appear, asking to add the new hardware

  • Click the Next button and select the option as mentioned in the following diagram

  • Click the Next button and select the Network Adapters from the list as mentioned in the following picture and click next

  • In the next window select Microsoft from the Manufacturer List on the left and select Microsoft KM-TEST Loopback Adapter from the Network Adapter List on the right and press Next

  • Click next to start installation and click the finish to complete it.

  • Now open networking and sharing center and assign the IP to the newly installed network adapter

  • Right Click on this adapter and select the properties, the following window will appear

  • Uncheck IPv6 then select IPV4 and click the properties button and select Use the following IP address and assign the IP address as shown

  • Press the Ok button and then press the close button

  • Now unzip the oracle database 11g 64 bit setup files. Unzip the files in the same folder.
  • Run the setup.exe file as administrator, select yes if it display following warning.

  • Uncheck the “I wish to receive security updates via My Oracle Support” and click Next as shown below

  • The following warning will appear, click yes and continue

  • Select “Create and Configure a Database” and click Next

  • Select Desktop class and click Next

  • Set the password on the next screen and click Next

  • Click the finish button on the following screen

  • The setup will start as shown in the following diagram

  • Check both public and private networks and click the Allow access button

  • The Database Configuration Assistant will start automatically as shown

  • The following window will appear, click the Password Management button as shown

  • Uncheck the scott account and set the New and Confirm password

  • The installation is successfully completed:) Click the Close button.